Middle jacket tank:
1.SUS304, thickness 6mm
2.Working pressure inside jacket 0.25Mpa
3.Can be cooled by cooling /chilling water
4.Insulation media: Aluminum silicate
External tank:
1.SUS304, thickness 3mm,
polished after grinding welds flush
2.Special whole cover suspension loop dealing method, ensure loop anti-rust & anti-water & beautiful appearance
Lid technic:
1.Manhole sealed cover, thickness: 10mm
2.Mounted on the lid: vacuum device, vacuum pressure meter, vacuum sucking valve with material filter, air breather, spices adding bucket, , archon light, sight glass window, cleaning spray ball
Instruction
When running vacuum pump,observe the vacuum pressure gauge in the main pot,once the vacuum pressure is up to the process standard,close the vacuum pump;
If the vacuum pump has the function of setting the vacuum degree,you can preset it so that when the vacuum pump reaches the fixed amount,the pump will automatically stop.
Before starting the vacuum pump,you must ensure there is enough water in the circulating water tank,otherwise the pump would be in damage.
If there is no water sucked into while the vacuum pump starts to work,a sharp noise would occur,in this occasion,please stop the vacuum pump quickly and check if there is water sucked into the pump.
When the vacuum pump is working,it is the best to stop heating(except that heating is within process request).Because during heating,water will volatilize and positive pressure will be produced,making effect on the vacuum degree that even up to 0.5Mpa;